CREE CAN-EDG Edge Series LED Canopy Structure Light Fixture

ShineRetrofits Input:
The CAN-EDG Series Canopy Petroleum Structure Light Fixture by CREE features a slim, low-profile design with a weathertight LED driver mounted in extruded aluminum.  Proudly made in the U.S.A. and includes a ten-year warranty.  Customize the fixture with the selections above and check out the spec sheet for additional information. 

DLC qualified. Exceptions apply when ordered with 1S, 3M, 5M, 5S, and 15 optics, or when ordered with 25, 40, or 70 optics and 40 LEDs at 350, 525, or 700mA or 60 LEDs at 350mA. Please refer to www.designlights.org/QPL for the most current information

Construction & Materials:

• Slim, low profile, easy mounting below deck design
• Luminaire sides are rugged die-cast aluminum with integral, weathertight LED driver compartment and high-performance heat sinks specifically designed for LED applications
• Direct mount J-Box sized to fit through existing 4" (102mm) diameter mount holes and designed for through-wiring and wet location installations. Mounts directly to canopy with lag bolts (by others). XA-CLSB16 accessory kit required when mounting to solid surfaces. Mating surface is gasketed to prevent water leak through. Includes leaf/ debris guard
• Pendant mount luminaire is supplied with a 3/4" (19mm) NPT stainless steel pendant connection and single 5' (1.5m) cord out of the top of the pendant. Longer cords available; consult factory. Includes leaf/debris guard
• Uplight luminaire is supplied with a heavy gauge stainless steel mounting bracket and convenient anchoring holes to accommodate four 3/8" (10mm) or four 1/4" (6mm) bolts (by others). The weather tight J-box is designed for through-wiring and wet location installations
• Exclusive Colorfast DeltaGuard® finish features an E-Coat epoxy primer with an ultra-durable powder topcoat, providing excellent resistance to corrosion, ultraviolet degradation and abrasion. Black, bronze, , silver, and white are available
• Weight: See Dimension and Weight Charts on pages 1 and 13

Electrical System:

• Input Voltage: 120-277V or 347-480V, 50/60Hz, Class 1 drivers
• Power Factor: > 0.9 at full load
• Total Harmonic Distortion: < 20% at full load
• Integral 10kV surge suppression protection standard
• To address inrush current, slow blow fuse or type C/D breaker should be used
• Maximum Source Current: 40-80 LED: 0.15mA; 100-240 LED: 0.30mA

Regulatory & Voluntary Qualifications:

• cULus Listed • Suitable for wet locations • Enclosure rated IP66 per IEC 60529 when ordered without P or ML options • Consult factory for CE Certified products • 10kV surge suppression protection tested in accordance with IEEE/ANSI C62.41.2 • Meets FCC Part 15 standards for conducted and radiated emissions • Luminaire and finish endurance tested to withstand 5,000 hours of elevated ambient salt fog conditions as defined in ASTM Standard B 117 • Meets Buy American requirements within ARRA • DLC qualified. Exceptions apply when ordered with 1S, 3M, 5M, 5S, and 15 optics, or when ordered with 25, 40 or 70 optics and 40 LEDs at 350, 525 or 700mA or 60 LEDs at 350mA. Please refer to www.designlights.org/QPL for most current information